Wasatch Reptile Expo

I biked to the Utah State Fairpark for the Wasatch Reptile Expo to see some lizards and snakes.

Lots of people

Star of the day: a black-throated monitor

Some videos I took: 1, 2, 3, 4

A cute chameleon

Cute bearded dragons enjoying some light: video

A little girl with a big snake

A dude with a big snake

A big turtle

The salamanders: video

We have birds too

An artist drawing a crocodile

The sacrifice

Comments

Aiwa XK-009 overhaul

I won the yahoo auction for the legendary Aiwa XK-009 at about 45000 yen. It is considered to be the very best aiwa cassette deck from aiwa. Although it was working, as expected, there were some issues. The biggest problem was that it suffered from unusually high w&f, which was very audible. The previous owner installed the belt in a wrong way - the belt was wrapped around a screw. The belt was left with some rails-like groves. This deck is very sensitive to the belt. So I ordered a new set of belts from fixyouraudio. It was not the best belt for this machine (the best ones are from a website called something communication). I always ordered belts from fixyouraudio. I always had good results from them and expected no difference this time. The aiwa xk-009 was quite a pain to take apart. I took apart most of it except for the fast-forward/backward mechanism, which does not affect the performance. I removed the old oil and applied new oil (crc lubricant). The all belts were repla...

Sony wm-DDII PB level pots test

I made a test tape with 315Hz tone at 0dB with my Nakamichi CR-5. According to the sony service manual for DDII, I am supposed to adjust the pots so that the output voltage at test points is 32mV (my previous value was about 36mW), so I did that. However, it actually sounded worse after the adjustment. The middle was muffle and turning off the dolby made things much better. That reminded me of my D3 which was the opposite with big middle. The level pots in my D3 had been set to quite high to match the meter of device (to 0dB) (This might not be correct as different manufacturers could have different meter standards). I speculated that maybe reducing the pot level caused the dull mid (Dolby error). So I increased the output to max on left (55mV) and indeed, the mid was back. Turning the dolby on and off gave relatively small change compared to before. So what is going on? According to the forum post ( https://www.tapeheads.net/threads/p-4-l300-flux-density.8179/ ), the sony referen...

Attempting to improve the bass on my DD walkman

I saw a post on the tapeheads forum where mihokm posted his guide for improving the bass response on the DD walkman. He pointed out that many DD models had thin bass and it can be fixed by replacing the tantalum capacitor (potentially aging and faulty) between the NF pin and the bias pin of the BA3304F preamp chip. He said if that capacitor was faulty due to its age, it could lead to a weird peak around 100 Hz, which I has experienced before. Also, he said increasing the capacitor from 10uF to 47uF could improve the bass response. While my DDII does not have the same bass issue he described (20+dB drop at 20Hz), my D3 does, so I replaced the tantalum caps on my D3. I also replaced the electrolytic capacitors (from 220uF to 560uF polymer) before the headphones socket as instructed to lower the cutoff of the high-pass filters and thus further improve the bass response (kind of a shame because the "original" ones were Nichicon gold). 220uF is fine for high-impedance headphones...

cliz305

Search This Blog